Versions with electromechanical limit switch (RB400/RB600/RB1000) and with inductive limit switch (RB400P/RB600P/RB1000P).
User-friendly: the Nice Blue BUS technology, enables to power and control a maximum of seven couples of photocell using two wires only.
Practical: the control unit and PS124 buffer battery (optional) can be connected by means of a simple connector and can be housed directly inside the motor.
Advanced: RB400, RB600 and RB1000 are equipped with a temperature sensor: adapt the motor power to the climatic conditions and at the same time thermal cut-out. A master/slave selection automatically synchronizes two motors. This means it is possible to automate 2-leaf sliding gates set opposite each other.
Intelligent: thanks to the obstacle detection system and automatic programming of the working times. Self-diagnosis by means of a flashing light. 8 programming levels.
Safe: acceleration and deceleration can be adjusted at the beginning and end of each opening and closing.
Sturdy: base and release in pressure die cast with easy to open handle.
Very quiet: gear motor on bearings.
For sliding gates weighing up to 400 kg. Electromechanical gear motor with Nice BlueBUS technology. Versions with electromechanical limit switch (RB400)
RB400 – 1 irreversible electromechanical gear motor, with incorporated control unit and OXI plug-in receiver which can beused for connections via Nice Blue BUS
FLOR2R-S – 2x transmitter 433.92Mhz, 2 channel
4.0m Nylon Steel-reinforced gear rack
|Power supply (Vac 50 Hz)||230|
|Work cycle (cycles/hour)||35|
|Dimensional and General data|
|Protection level (IP)||44|
|Working temp. ( °C Min/Max)||-20 ÷ +50|
|Dimensions (mm)||330x210x303 h|
So easy to setup
1. Bolt the motor down
2. Screw on the racking
3. Press two buttons together at the same time for 3 secs
for Auto self learn – that’s it.